Kaiser Baas X1 Open Case Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I have created an open case for my Kaiser Baas X1 Action Camera. As I would like to be able to charge my camera while…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 103
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
I have created an open case for my Kaiser Baas X1 Action Camera. As I would like to be able to charge my camera while using it. Sometimes you need to take timelapse's that could take hours to complete and the battery does not last that long. In the standard case you also can not access some buttons which I found annoying.
This one has been designed to use a Go Pro type connection bracket similar to the original case, but I have also used some other Ideas that I could share later if there is any interest.
The case is designed to use as little as possible filament, but still be strong enough. The case I a little bigger than the Camera so that I could use a soft rubber or sponge in the corners to make sure there is no wear on the camera itself.
Category: 3D Printing