Spatula and Spoon Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A practical spatula or spoon holder to keep your counters clean while cooking.
- Ocena
- 5 / 5
- Polubienia
- 61
- Pobrania
- 438
- Wydruki
- 5
- Wyświetlenia
- 1069
- Oceny
- 5
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A practical spatula or spoon holder to keep your counters clean while cooking. This holder elevates the utensil to help cool it quickly while catching the drips in a small dished area. The holder was especially designed such that it minimally warps during annealing of HTPLA; which makes this easy to print and use. Annealing the HTPLA (or printing in PETG) even makes this dishwasher safe!
Print Settings
Printer Brand:
Prusa
Rafts:
No
Supports:
No
Resolution:
0.2 mm
Infill:
20%
Notes:
I found out that 3 top/bottom layers, and shells is not sufficient to keep it water tight. 5 layers and perimeter shells seemed to work better. For best results print with PETG or a high temp PLA (HTPLA, etc.).
Post-Printing
If using HTPLA - be sure to anneal to provide the best heat resistance. I also found that if the part wasn't annealed the colors become non-uniform after cleaning in a dishwasher, but it still actually worked fine. Annealing process: Preheat oven to 100C/212Frn2. Bake for 5-10 minutes (as far away from the heating coils)rn3. Cool very slowly to minimize warping (just turn off the oven and let it cool).
Custom Section
Other:
I designed this to hold wooden spatulas I made on a lathe. But it works just as well for spoons and other kitchen utensils.
Category: Kitchen & Dining