AtomRC Killer Whale - Removable FC Tray
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Removable tray for flight controller to fit AtomRC Killer Whale
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 34
- Wydruki
- 0
- Wyświetlenia
- 242
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
Custom flight controller tray and attachment rails for AtomRC Killer Whale.
The rails are glued into the middle slot and should be pushed as rearwards as possible (see images). They are designed for M3x6mm threaded inserts with an OD of 5mm, such as these.
The default tray is designed to fit a flight controller using M2 fixings in a 25x25mm pattern (specifically the old Matek F405-WSE) so you will need to redesign the mounting holes if you need alternative mounting points. The rear of the tray has plenty of tie down points for cable management.
Fusion 360 f3d/f3z files are provided if you need to edit either model!
The rearmost screws can't be reached unless you make a hole in the top of the fuselage
Printing:
- Any material is fine, I used PLA
- The models can be printed however you like, I suggest a minimum of 2 walls and 20% infill
Assembly:
- Sand the foam before gluing the rails in to improve adhesion
- Attach the tray itself to the rails when gluing the rails in to ensure the hole spacing stays correct
- Use M3x8mm screws to attach the tray to the rails