Modular Drying Tree for Breast Pump and Baby Bottle Parts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I made this modular tree specifically because my existing tree and every other one I can find requires careful tetris…
- Ocena
- 5 / 5
- Polubienia
- 78
- Pobrania
- 359
- Wydruki
- 5
- Wyświetlenia
- 2787
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Share Alike
I made this modular tree specifically because my existing tree and every other one I can find requires careful tetris every wash to fit all the highly-irregularly shaped odds and ends.
The5-arm part fits pump flanges, as well as small bottles.
The10-arm part fits nipples, pump valves, bottle caps.
Thegrid consists of 20mm wide slots, and fits bottle air vent parts.
Thebase can be built upextensions as needed.
The female threads are 18x4.0 mm.
The male threads are undersized so there is a ton of clearance to allow running your printer on the coarsest settings for fast printing, and this has the benefit of letting you spin the holders while washing.
Print Settings
Supports:
No
Resolution:
0.6mm+ x 0.25mm
Infill:
60% - (thicken walls until skinny parts are 100% filled)
Filament:
Generic PETG
Notes:
All parts except the extension are meant to be oriented flat on the bed and require no supports.
The**extension**, I oriented vertically with a very wide brim to avoid having to use supports to keep the threads smooth, and to avoid an interrupted-thread design which would lay flat with no supports or brim just fine.Category: Kitchen & Dining