Giant soda can prop

Introduction:

• A comically large soda can. You can either use it as a fun prop, use it to store small items, or use it for fursuiting!

File name explaination:

• Two folders: WithLug and WithoutLug
  • WithLug:
    • The cans in this folder have built-in strap lugs for easy carrying.
  • WithoutLug:
    • The cans without strap lugs are a close mimic of a 330ml soda can, simply 1.5X the size.
    • If you wish to carry the can around your neck or shoulder, print the Strap_Top and Strap_Bottom. Refer to the photos for how to strap up the soda can.
  • Note: All the cans use 25mm (1 inch) wide nylon strap.
• Two suffixes: _Solid and _FanGrill
  • _Solid:
    • Both the body and the cap is solid, suitable for storing small items.
  • _FanGrill:
    • Both the body and the cap are fan grills, suitable for putting a small cooling fan inside the soda can.

Dimensions:

• External dimension:
  • 99 mm (3.9 inches) in diameter, 187 mm (7.4 inches) in height.
• Internal dimension:
  • 95 mm (3.7 inches) in diameter, 183.5 mm (7.2 inches) in height.
  • Note: Parts of the interior is narrower, refer to the photos for detail measurments.

Wrap/Livery:

• If you wish to wrap the soda can with graphics as seen in the photos, the dimension of the graphics is 140 mm (5.5 inches) in width, and 311 mm (12.2 inches).
• Remember to utilize bleed.

Printing instruction:

• These files should be printed with support:
  • StrapHarness_Top
  • SodaCanBody_WithLug_Solid
  • SodaCanBody_WithLug_FanGrill
• Material:
  • Tested successfully with both PLA and PETG.