Onewheel Pint bearing cover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Work in progress. Driven approx. 3000 km without problems.. so far..
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 61
- Wydruki
- 0
- Wyświetlenia
- 478
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Work in progress.
Driven approx. 3000 km without problems.. so far..
it may have to be scaled up for 1-2% to stick to the hub a little better. will test it - sometime xD
simple bearing cover splitted into 2 parts so there is no need to dissasemble your onewheel ! maybe i will add a 1 piece version in the future.
first clean your bearing and put some silicon grease on it OR put the grease into the notch of the cover. then you only have to snap both sides in and glue them together. Be careful with the grease, glue will not stick on it ;-) it is a little bit tricky to install it on the mag handle site. You have to use the bearcovmag files. If they don't want to stay in the hub then scale up the files about 1-2% or put on a little bit of glue
Attention!
I DON'T GUARANTEE that this cover seal the bearing/ the hub motor against fluids, dust or anything else!!
Use it on your own risk!
I am not responsible for any damage to your onewheel!
Print Settings
Printer:
Geeetech A10
Rafts:
No
Supports:
Yes
Infill:
10%
Filament: 3D Jake ecoPLA black/white