D1mini Sensor Case - LD2410C, BH1750

I Modified the project to be able to store a LD2410C instead of the temp sensor.

Also i opened part of the top case for the light sensor, as the measurements were pretty low.

There is plenity of space for the cables, so you should be able to even make it shorter.

My cables are a bit too long but it works perfectly

The case it's for the ESP32 D1 Mini but if you remove the center square on the top, you can fit a Wemos ESP8266 in there.

This is the code on ESPHOME for the Wemos ESP8266 D1 Mini:

i2c:

  sda: GPIO4

  scl: GPIO5

  scan: false

uart:

  id: uarts

  tx_pin: GPIO15

  rx_pin: GPIO13

  baud_rate: 256000

  parity: NONE

  stop_bits: 1

ld2410:

  timeout: 30s

  max_move_distance : 6m

  max_still_distance: 0.75m

  g0_move_threshold: 50

  g0_still_threshold: 20

  g1_move_threshold: 50

  g1_still_threshold: 20

  g2_move_threshold: 40

  g2_still_threshold: 40

  g3_move_threshold: 40

  g3_still_threshold: 40

  g4_move_threshold: 40

  g4_still_threshold: 40

  g5_move_threshold: 40

  g5_still_threshold: 40

  g6_move_threshold: 30

  g6_still_threshold: 15

  g7_move_threshold: 30

  g7_still_threshold: 15

  g8_move_threshold: 30

  g8_still_threshold: 15

sensor:

  - platform: ld2410

    moving_distance:

      name : Moving Distance

    still_distance:

      name: Still Distance

    moving_energy:

      name: Move Energy

    still_energy:

      name: Still Energy

    detection_distance:

      name: Detection Distance

  - platform: bh1750

    name: "BH1750 Illuminance"

    address: 0x23

    update_interval: 20s

binary_sensor:

  - platform: ld2410

    has_target:

      name: Presence

    has_moving_target:

      name: Moving Target

    has_still_target:

      name: Still Target