Eibos Cyclops - Easy Access & Fillament change Spacer Assembly
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Updated 25-02-22 Split main body, pivot back plate hex corrected to 7.1mm across flats for M4 nut I have designed this…
- Ocena
- 5 / 5
- Polubienia
- 26
- Pobrania
- 107
- Wydruki
- 3
- Wyświetlenia
- 731
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
Updated 25-02-22
Split main body, pivot back plate hex corrected to 7.1mm across flats for M4 nut
I have designed this spacer and pivot assembly to make it easyer to change the filament on the Eibos Cyclops dryer.
As good as the dryer is, it is a pain to change the filament, having to feed the PTFE and filament into the cover and have the Spool on the wheel. It just dont work!
This spacer will allow you to feed the filament into the PTFE tube in the pivot block, and then simply put on the lid! Simples!
These are printed in PETG, 0.2mm layers, 100% infill (only thin walls)
I was going to reprint in ABS but no need.
Print Settings
Printer:
Voron V2.4
Rafts:
No
Supports:
Yes
Resolution:
200
Infill:
100
Filament:
Sunlu PETG PETGBlack/Red
Category: 3D Printer Accessories