Balcony Box
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A mechanised box with 2 "balcony" drawers. The drawers open with a 120º rotation of the lid.
- Ocena
- 4,8 / 5
- Polubienia
- 113
- Pobrania
- 496
- Wydruki
- 5
- Wyświetlenia
- 4281
- Oceny
- 5
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A mechanised box with 2 "balcony" drawers. The drawers open with a 120º rotation of the lid. Assembly walkthrough on YouTube
STL Files
• Balcony-Base-1X.stl
• Balcony-Top-1X-V2.stl
• Balcony-Screw-1X.stl
• Balcony-Drawer-2X.stl (Print two of this)
• Balcony-Drawer-Floor-2X.stl (Print two of this)
Print instructions
Designed tolerances
• Sliding parts tolerance: 0.25mm
• Fixing parts tolerance: 0.15mm
All the files are in their correct z-up orientation. This would avoid the need of any support (except Balcony-Drawer-2X.stl which still needs a small 5mm tall support for best results)
Only allow supports for "Balcony-Drawer-2X.stl"
Most of the model prints without supports, except a small 5mm tall support (on bed) required for one of the STL for best results.
Post-printing
If you get elephant foot (the small edge around the first layer){:target="_blank"}, strip if off with a box knife for precise fit of the moving parts.