Honeycomb Fan remix for Turing Pi v2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This lid has a smaller hole with a fan grid and mounts for a Noctua 40mm fan (https://amzn.to/3M0krLx)
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 17
- Wydruki
- 1
- Wyświetlenia
- 320
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I needed a lid with a smaller hole, so I whipped this up in OpenSCAD.
The default fits a Noctua 40mm fan (https://amzn.to/3M0krLx) over top of a Turing Pi v2 board.
Everything is adjustable in Configurator using OpenSCAD. The overall size matches the Mochi case, but that can be changed in the editor. I did no refinement, basically everything is just sharp edges and inefficient pathways but it printed fine.
Material: PETG but it doesn't matter much
Settings: It is basically just a featureless square, so the only thing that matters is your top/bottom layer depending on which you want to be the visible side. Make sure the fan grate is at least 2 lines wide though ('thick' value should be around 1.5-2x nozzle width).