Combustion Inc Magnet Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holds the display and two probes. It does not need to be removed for operation or charging.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 45
- Wydruki
- 0
- Wyświetlenia
- 435
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
Magnetic holder for the display and two probes from Combustion Inc.
The holder fits quite firm around the timer and doesn't need to be taken of for charging or operation as there is cutouts for both. The probes are just hung to the sides and can easily be taken of if necessary.
I printed this on a 0.4mm nozzle with PETG. Configure a pause at layer 30 to insert two magnets that are 10x5mm. The holes are a bit bigger for easy insertions and allow for variation in magnets. I used a drop of ca glue to keep them in place. Make sure you're not using a magnetic nozzle. The magnets I used hold really firm so smaller ones could easily be used as well.