TinkerTop
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
TinkerTop is a Gaggia Classic project that can be added to the Gaggia Espresso machine to add a place for modifications.
- Ocena
- 5 / 5
- Polubienia
- 3
- Pobrania
- 42
- Wydruki
- 0
- Wyświetlenia
- 445
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
-This is still a work in progress, some things will change in the future-
TinkerTop is a Gaggia Classic project that can be added to the Gaggia Espresso machine to add a place for modifications. The goal is to make a universal base to print once, a cheap and easy to exchange front plate to play around with. On the right hand side there is an almost-through hole to add a rotary dimmer.
It can be printed with very little support and on a smallish printbed (20x20cm).
Tip: print a third "TinkerTop_Base_Key" to remove the ones that are in use. It is a very tight fit and I can not get them out without help. It may show like a weak connection but the connection is rock solid, there is hardly any torsion possible. I is almost as ridged as a solid printed part.
The "TinkerTop Plate Gaggiuino ..." uses the same Nextion mounting plate as the default print of the official Gaggiuino project. housingback.stl
In the near future I will add a place in the rear of the base to add a Pogo-pin connector for programming the ST-Link without removing the top.
Work in progress, some things will change in the future. Most of it is tested by me, but not all is. Untested still is the "TinkerTop Bottom ...".
2023-04-20:
Changed "TinkerTop Bottom" to slide-in design. This also changed Base Front and Rear
Changed "TinkerTop Base front" for better alignment of the insert plates
Minor change to air vents: size, spacing and orientation