ICD 12g changer knob
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A paddle knob for the end of the ICD 12g CO2 changer lever arm. It fits directly on the end of the lever and has a…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 127
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution
A paddle knob for the end of the ICD 12g CO2 changer lever arm. It fits directly on the end of the lever and has a hole that lines up with the one in the end of the lever. The sides are tapered for a better grip, and the long nose helps prevent the lever from hooking on clothing or vines and being pulled accidentally.
Print Settings
Printer Brand:
Prusa
Printer:
Rafts:
No
Supports:
No
Resolution:
0.15
Infill:
30
Filament: Prusament PLA Grey Post-Printing =============
Attachment
Mine is secured with a 5/32" roll pin, 5/8" long. It was cut down from 3/4" long. To start one side, I drilled out the lower side with the next size larger drill bit by hand (no power tool). The other side was left alone and did not crack. I considered putting different hole sizes in the model, but there are a variety of ways to pin the knob on to the lever (such as a set screw) that should work without as much effort. I am also not sure if drilling one side is necessary for the roll pin.
It took a beating while hammering the roll pin in and seems plenty tough.Category: Sport & Outdoors