Alioth IOM sailboat logos
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
These are 2D files in several formats so that you can make your own stencils or stickers to apply to the Alioth IOM 3d…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 65
- Wydruki
- 0
- Wyświetlenia
- 672
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
These are 2D files in several formats so that you can make your own stencils or stickers to apply to the Alioth IOM 3d printed boat.
I included the hull numbers just so you could get a reference for the size. The font is 20mm Arial Rounded Mt Bold. I used lowercase letter “L” for the ones because I like the look better.
You can see in the logo photo sequence how to assemble it.
- Remove the extra vinyl.
- Then cut just at the edge, leaving a millimeter of piece of white backing.
- Align the edges and put a bit of tape at each end.
- Apply the transfer tape and apply.
A spray made of denatured alcohol diluted 50% with water and a drop of liquid soap will allow you to slide the vinyl around a bit. Then squeegee it to apply.
Here is the build thread https://www.rcgroups.com/forums/showthread.php?4112127-Alioth-3d-printed-IOM-sailboat
Category: R/C Vehicles