Fabric Tape Measure Holder (magnetic)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I had a problem with the center pin breaking on Chillhaus' original version of this holder, so I redesigned it.
- Ocena
- 4,833 / 5
- Polubienia
- 65
- Pobrania
- 252
- Wydruki
- 5
- Wyświetlenia
- 1740
- Oceny
- 6
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Using 6x2 mm magnets, I was able to eliminate the two problems I had with the old design. . . the center pin breaking, and my tape's metal tang not fitting the slot. I also added a lip to the base so the two parts fit together nicely. 6x2mm (actually 1.62) magnets hold the parts together. Mine snapped right in, but a tiny amount of CA glue might be advised. I printed this using PLA on an Ender 3 Neo with 20% infill. A very small amount of support is needed to insure that the two vertical magnet pockets remain round. I used the defaults in Cura. If your parts come out a bit snug, twisting the pair together will wear them in.