KingKong ET100/115/125 parametric case

I picked up a KingKong ET115 and wanted a snug case for it.

I have printed the case for the ET115 as that is what I own but I had searched the net and asked people that have the ET100 and ET125 for the outer prop guard diameter to make those, it should be fine but just note I did not print the 100/125

I have included the f3d file and it is very customizable, shell thickness, padding, height, dome diameter, diagonal measure, printer tolerance and more that I can't remember off the top of my head.

That said you could probably change the settings to make it work with any X framed quad (true X frame not some arms at a weird angle), might have to replace the dome with a square or something to fit but it should be easy enough to do.

I am very pleased with the way it turned out, you can throw it in your bag, or strap it to your backpack and not worry about anything being able to damage the quad.

I printed mine out of PETG but you can print it out of whatever but it does have thin walls so if printed with PLA and left out in the heat it will most likely warp, better to use something other than PLA.

Print Settings

Rafts:

Doesn't Matter

Supports:

Resolution:

0.25

Infill:

Notes:

I chose 0.25 as I wanted it printed quicker.

Supports are needed for the top but not the bottom.

Unless you increase the shell thickness the infill will not matter, with the thickness I have selected and a perimeters of 2 it prints solid without using infill but that is up to you and your slicer.

Category: R/C Vehicles