Modified Cable Holder 155 * 20 mm for 6 cables
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Let me start off by saying that I did not design this USB cable holder but in looking around I really liked it a lot…
- Ocena
- 5 / 5
- Polubienia
- 4
- Pobrania
- 42
- Wydruki
- 1
- Wyświetlenia
- 203
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution
Let me start off by saying that I did not design this USB cable holder but in looking around I really liked it a lot but I like rounded corners especially on things that are permanently mounted, too many accidents on square hard corners in this house.
All credit for the design goes to Yannick_Turbang he is the one that put in the majority of the work, all I did was extend the front my a couple mm so I could round it over better then rounded the edges.
it looks great, it works as good as the original but now no one is going to get hurt. (Yes, I live in that much of an accident prone of a house.)
Print Settings
Printer:
mine
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
20-30
Notes:
it prints fine at 0.2, I went 0.15 just to make nicer rounded edges.
Category: Organization