Low Voltage - Terminal Block - 12 post - 45 degree
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
NEW parametric version at http://www.thingiverse.com/thing:2171007. USE AT OWN RISK! Low voltage terminal block with…
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 41
- Wydruki
- 0
- Wyświetlenia
- 461
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Public Domain
NEW parametric version at http://www.thingiverse.com/thing:2171007.
USE AT OWN RISK!
Low voltage terminal block with 12 posts set at 45 degrees for easier wire insertion, and easier printing.
Bill of Materials:
1x printed terminal block
12x #4-40x3/8" screws
12x #4-40 nuts (1/4" Across Flats)
24x #4 flat washers (3/8" Outside Diameter)
2x Countersunk screws to mount.
For general use, two wires should fit nicely between the nut and the washer.
Using either aluminum tape, copper tape, or a wire, you can bridge/bond posts across from each other.
Not recommended for high voltage or high amperage. I am not an electrical engineer, so I will limit its use to 12VDC on a 3D printer, or similar projects.
If you mount it to metal, I recommend covering the bottom with electrical tape.
Print Settings
Printer:
Printrbot Play
Rafts:
No
Supports:
Doesn't Matter
Resolution:
0.15mm/layer
Infill:
25
Category: Electronics