Archery target pin variant.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Modification on an already excellent model from Prusalicinator. Added two small ears to hold target face.
- Ocena
- 4,75 / 5
- Polubienia
- 23
- Pobrania
- 128
- Wydruki
- 4
- Wyświetlenia
- 482
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
I optimized printing for my self with 1 mm nozzle. Each pin is about 2.4g of material and can be printed in about 2-3 minutes. Layer height- 0.5mm, Layer width- 1mm. My printer required some optimization, had to adjusts “extra prime amount” to 0.8 mm^2 in Cura.
Perimeters- all (10)
If printed with 0.4 nozzle it can be extra sharp, and slow :)
I would refrain from prining it in dark PLA for use in summer outdoor season, PETG should be good.
if you are printing many copies at once make sure your bed is leveled.
Print this for you club! :)
Great thanks again to Prusalicinator!
Edit 24.08.2023: Initial moddel is now called Long, added Medium and Short variants. Mid is enough for most targets, short is good for very stiff hay bale targets.
500 of these were used in Berlin 2023 Hyundai World Archery Championships, on the practice field :)