MPCNC Primo Cable Run Mounts
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The new MPCNC Primo was recently released and there's not a lot of parts for it for add ons. This is my take of a…
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 48
- Wydruki
- 0
- Wyświetlenia
- 354
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
The new MPCNC Primo was recently released and there's not a lot of parts for it for add ons. This is my take of a mount for a cable run for the spindle and Z stepper motor.
It's designed for the 25.4mm (1") tubing and 27mm angle aluminum. I just use zip ties to hold it on, but you could drill a hole through the top part and use a bolt.
I used 4mm x16mm cap bolts to mount it to the rail. The clamp should be faced so that the angle is towards the trucks. That way you can push it closer to the truck for more clearance.
The angle aluminum should just clear the edge of the core part of the machine and have a few mm clearance above the top rail.
Print Settings
Rafts:
Doesn't Matter
Supports:
No
Infill:
35%
Notes:
You'll want to flip the clamps so that the flat side is down. I didn't pay attention to which way the Z+ direction was when I designed it.
Category: DIY