PEZ base holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Stores PEZ dispensers to prevent them from falling over.
- Ocena
- 4,75 / 5
- Polubienia
- 17
- Pobrania
- 219
- Wydruki
- 3
- Wyświetlenia
- 1670
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Share Alike
I made a PEZ base holder for my girlfriend. She has over 1000 PEZ at this point. She stacks them everywhere and they will sometimes fall over and like dominoes they tend to take out several dispensers at a time.
I iterated a few times until I got a satisfactory fit. i created a single version and then a 5x version (200 x 30 mm) to fill up my print bed horizontally. I can print 6 at a time.
I tried both PLA and PETG. PLA seemed easier due to stringing.
Printing tips: I also printed them with zero top layers to save on material. I printed them at 102% scale and 0% infill to create a slightly tighter fit since I use a 0.6 mm nozzle.
They tend to fit most snugly when the the pillar is towards the front of the dispenser.