Prusa Mini Time Lapse Arm
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a 3D Printed arm to make automatic motorized time lapses on a prusa mini using a webcam.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 792
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution
This is a 3D Printed arm to make automatic motorized time lapses on a prusa mini using a webcam.
It uses an arduino & 28byj-48 stepper motor as the basic power drive.
More information, code and assembly on For more info, check out BuildComics.com: https://buildcomics.com/hero/3dp-and-dizzy-timelapses/
Some possible improvements:
- Make the gap between X - Axis stepper motor and the arm bigger, it's rather tight
- Make the arm slightly longer (two piece) so the center actually matches the center of the build plate
- use gears to get a smoother stepping/moving action (and possibly stronger)
Print instructions
Category: 3D Printer Accessories Summary
This is a 3D Printed arm to make automatic motorized time lapses on a prusa mini using a webcam.
It uses an arduino & 28byj-48 stepper motor as the basic power drive.
More information, code and assembly on For more info, check out BuildComics.com: https://buildcomics.com/hero/3dp-and-dizzy-timelapses/
Some possible improvements:
- Make the gap between X - Axis stepper motor and the arm bigger, it's rather tight
- Make the arm slightly longer (two piece) so the center actually matches the center of the build plate
- use gears to get a smoother stepping/moving action (and possibly stronger)
Notes:
All parts should print without supports. I used PLA, but I guess other materials (apart from flex obviously) will work fine as well.
Post-Printing
BuildComics
All the basic instructions are on buildcomics.com
Please note that the fit between the X-Axis stepper motor of the printer, and the arm is rather tight. Make sure you can freely move the Y - Axis all the way to the top before tightening completely.