Rostock Max V2 Door Handle & Door Frame
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a handle and frame for the opening on my Rostock Max V2 that I have built an enclosure for…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 136
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a handle and frame for the opening on my Rostock Max V2 that I have built an enclosure for (http://repables.com/r/447/) . I made some mods to the opening parts. No glue needed. Used small sheet metal screws .375 long to hold the frame on either side. Parts have holes on the back side to accommodate 6MM round magnets 6MM long. 8 per side and 16 for the door for a total of 32. I also used my Rostock Max V2 Temp Plate (http://www.thingiverse.com/thing:1547459). Tap the holes on the door handles with a M3 bolt.
Used a 15/64 drill for the door magnets. Make sure to check the polarity on the magnets before putting them in the door.
Pops nicely in place! https://youtu.be/FGAQYKtdi74
This setup helps keep warping to a minimum when printing ABS. Keeps the print chamber at about 92F to 96F.
Print Settings
Printer Brand:
SeeMeCNC
Printer:
Rafts:
No
Supports:
Yes
Resolution:
.25
Infill:
40%
Notes:
Used ABS. Remove the supports from all the small holes both on the handle and the door parts.
Category: 3D Printer Accessories