1 / 6
VOXELAB-Aquila X2 Bolt-on! filament guide (metal dual gear extruder) — zdjęcie 1
1 / 6

VOXELAB-Aquila X2 Bolt-on! filament guide (metal dual gear extruder)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Modified to suit my needs as I've upgraded to a (red) all metal dual gear extruder on my Aquila X2 which is higher…

Ocena
5 / 5
Polubienia
3
Pobrania
47
Wydruki
1
Wyświetlenia
381
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution

Modified to suit my needs as I've upgraded to a (red) all metal dual gear extruder on my Aquila X2 which is higher than the original and other replacements. (~23.95 mm high).

Widened the bearing holding area to fit a 608zz bearing with V sleeve over it and spacers on either side, changed the screw size to fit an M4 20mm screw with lock nut.

Also raised the bearing holding area to suit the additional height of the extruder.

Added spacers for the filament runout sensor to mount with 25mm M3 screws.

Printed the guide at 0.2 layer height, 25% infill.

Printed the bearing sleeve/ring at 0.1 layer height, 20% infill? (I forget the infill tbh), same with the spacers.

You need to print:

1x guide

1x ring

2x spacers

Additional hardware:

2x M3 25mm screws

1x M4 20mm screw

1x M4 nut, I used a nylon locking nut.

1x 608zz ball bearing

Youmay need a tiny dab of superglue on the inside of the spacers and the ring. Mine were a fraction loose but otherwise fine.

Print Settings

Printer:

Voxelab Aquila X2

Rafts:

No

Supports:

No

Resolution:

0.2

Infill:

25%

Filament:

eSun PLA+

Black How I Designed This ===================

Took the original into tinkercad, did some basic edits / additions after getting the measurements right then took into blender for final adjustments and (lots of) cleanup.

Category: 3D Printer Accessories

Tagi