1 / 6
Ultimate Bowden PTFE Tube Clamp (no slip and rotation) — zdjęcie 1
1 / 6

Ultimate Bowden PTFE Tube Clamp (no slip and rotation)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Clamp for bowden PTFE Tube to increase print quality by eliminating tube slip and rotation

Ocena
5 / 5
Polubienia
22
Pobrania
135
Wydruki
3
Wyświetlenia
1093
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This clamp should enhance any standard G1/8 (M10) fitting for 4mm PTFE tubes.
It is able to hold any spinning / slipping / moving back and forth tubes. If the tube moves, it can both damage itself being cut with the teeth of a fitting and affect print quality, as you need to set greater retractions.
If you have such a problem, this part will do it right without overtightening the tube.

For one fitting you will need:

  • print two parts, as one is just a half (print them standing on the wider side with supports) 
  • get a sanding paper (i think 120-300 grit should do the best job) and cut a piece about 7x11mm. I used the old paper for the sanding machine 
  • two zip ties 

Instructions:

  1. Screw your fitting into hot end radiator or extruder
  2. Put the tube in and fix it in place as you normally do
  3. Slide one printed piece onto the fitting from the side
  4. Wrap the sanding paper around the tube (working side to the tube) and move it to the shallow slot on the inside of the part just like on the photo
  5. Slide the second piece and make sure sanding paper is wrapped around the tube properly
  6. Tighten the whole part around with two zip ties until they barely move
  7. Done :)

On the last photo you can see the result. The tube was pulled after about 7 Hours of printing to take this photo. The teeth of the fitting are just small dents on the tube surface, that means, the tube did not move at all.

Tagi