Fridge Under-Shelf Applesauce Cup Organizer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
For anyone that has too much applesauce and not enough fridge space. Can hold five cups in a counter-depth fridge.
- Ocena
- 0 / 5
- Polubienia
- 51
- Pobrania
- 73
- Wydruki
- 0
- Wyświetlenia
- 1284
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial
Compatible with fridge shelves between 330mm and 343mm deep with a front edge height of up to 10mm and a rear edge height of up to 15.5mm. This was designed for a Samsung Bespoke counter-depth top fridge shelf.
This model is designed to be printed in several parts for expandability, replaceability, and compatibility (all parts can be printed on a Prusa Mini+). If you have a large enough build plate, some of the parts could be merged. No tools or extra hardware is required. The middle supports snap into detents at the correct location on the other structural parts.
The included STLs can be easily reshaped to fit your fridge shelf's measurements.
Print information:
- Print parts vertically to minimize supports and maximize use of build area
- Brim recommended when printing vertically to improve adhesion and reduce part sway during bed movement
- Perfect calibration not necessary - support connector has some wiggle room for imperfect prints
- It's a pretty forgiving design, nothing too special is needed
Parts can be printed at any orientation, provided layer adhesion is solid. The design can easily handle standard applesauce cups and does not rely on layer direction for extra strength.
The included gcode files are configured for detail 0.1mm layer height on a Prusa Mini+ and do take some time to print.