Bob-Omb Tissue Holder Improved
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A Tissue Holder
- Ocena
- 3,429 / 5
- Polubienia
- 224
- Pobrania
- 515
- Wydruki
- 12
- Wyświetlenia
- 3755
- Oceny
- 7
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Decor
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a remix of the Bob-Omb Tissue Holder I created in Fusion 360. I just increased the lip between the body parts for better friction and increased clearances between the locking parts.
Depending on your result the upper and lower body might not hold together strong enough to pull tissues out. I added some quickly designed interlocking parts, which you can just glue to the inside. That should hold everything in place.
Measurements: 17cm wide x 25 cm deep x 17 cm high
Printed on Anycubic Kobra using Anycubic and Overture PLA Filament
Print Settings
Rafts:
Yes
Supports:
Only really needed for the eyes. Depending on your printer upper and lower body might also need a few supports to get the bowls started.
Resolution:
0.3
Infill:
15%