Craftsman Table Saw Handle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A replacement handle for a Craftsman table saw.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 69
- Wydruki
- 0
- Wyświetlenia
- 593
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
I was missing a handle on my old Craftsman table saw and found it annoying to turn the knob without it. So I modeled a new one using Tinkercad to replace it.
The model uses a 50mm long 3/8" bolt and nut because that's what I had on hand and threaded well into the plastic knob. If using anything shorter you'd have to adapt the design for the hole to go deeper.
End cap is a pressure fit and popped in well for me by pressing it down on a table.
I printed both at the same time with the handle narrow side down and did a filament change to have the black/red transition.