The Owl House Emperor's Castle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Model of the Emperor's Castle from The Owl House
- Ocena
- 5 / 5
- Polubienia
- 21
- Pobrania
- 96
- Wydruki
- 2
- Wyświetlenia
- 629
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Architecture & Urbanism
- Licencja
- Creative Commons — Attribution
This is a model of the Emperor's Castle from The Owl House.
The standard version is 143mm long, 110mm wide and 235mm tall. It is cut into two pieces for printing, of 143mm x 110mm x 180mm and 76mm x 76mm x 100mm (length x width x height).
The small version is 72mm long, 55mm wide and 118mm tall. It is printed in one piece. Compared to the standard version, the crenellations and veins are thicker and the spike at the top of the spire are modified to reduce the overhang angle.
In creating this model, I've mostly used shots from either S1E18 or S3E3. Note that there are some inconsistencies between these episodes and that the backside is barely shown.
Print Instructions
The standard model is split into two pieces: “print toh emperors castle-castle.stl” and “print toh emperors castle-spire.stl”.
Both were printed at 0.2mm layer height and require supports on buildplate.
The small model is “print toh emperors castle-small.stl”. It can be printed at 0.15mm layer height and requires supports on buildplate.
If you want to support me, you can do so via this link: https://ko-fi.com/printingdaniel#