1 / 2
Self Filling PET Bottle Water Fountain (For birds and chickens) — zdjęcie 1
1 / 2

Self Filling PET Bottle Water Fountain (For birds and chickens)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Water fountain connected to a PET bottle (self filling) for birds and chickens, shallow to prevent drowning.

Ocena
5 / 5
Polubienia
55
Pobrania
513
Wydruki
4
Wyświetlenia
1710
Oceny
4

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Pets
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Someone i know wanted to print the version i remixed it from, but the bowl and cylinder itself was too tall for her purpose (chickens that are currently under a heat lamp), they would potentially drown because of the water level. So i looked at the original design, tweaked the interior of the cylinder and made the "bowl" shorter (water level is slightly below 10mm in depth, the wall of the bowl itself is 10mm and the "floor" of the bowl is 3mm for strength).

Link for PET bottle thread in Fusion: https://www.thingiverse.com/thing:2693686

Print Settings

Printer Brand:

Creality

Printer: 

CR10S PRO

Rafts:

No

Supports: 

No

Resolution:

0.2

Infill: 

10-20%

Filament: PETG highly recommended, but PLA works too.


 

Notes:

 

May need to use bridging settings for a nicer interior on the holes, slight line hanging in my case (only a cosmetic flaw, otherwise it works perfectly fine). Tested with 0.2mm layer height and it works fine.

Post-Printing =============

Potential Safety Issue

In case you get sharp edges on the exterior of the cylinder or the interior of the "bowl" (may happen in case of having problems with the z-seam like i did) you can hit it with a dremel, smooth sandpaper or some Scotch-Brite to smoothen things out, otherwise theres no post processing needed.

 

 

 

Category: Pets

Tagi