Grippy Keychain Containers

I had some requests to make the exterior of the container more grippy since the knurling was mainly esthetic, and after some tinkering this is the result i came up with. (Exact same design but with a different exterior.) Feel free to give me feedback on how grippy it is when opening/closing, especially if you dont have a lot of grip strength or sensitive skin!

UPDATE 1.1: I changed the smaller lid so it has the same connection point as the large one (they seem to print better), i also changed the large container thread to the same type as the small container.

UPDATE 2.0: I changed the thread to a bigger one with a bigger pitch, reinforced the attachment point and altered the interior dimensions (threads, interior dimensions and attachment points are identical to my other keychain containers V2 models).

Print Settings

Printer Brand:

Creality

Printer: 

CR10S PRO

Rafts:

No

Supports: 

No

Resolution:

0,16

Infill: 

30%

Filament: PrimaSelect PLA Black

Notes:

If you print on glass i recommend a higher bed temperature to keep it stuck, i tried printing at 50 degrees but it wouldnt stick throughout the entire print. If using BuildTak i recommend being very careful when removing the print so you dont damage the internal thread. DO NOT USE RAFTS, brim is a pain to remove and raft ruins the first layer on the actual container. If you want the exterior of the container and lid to be nice and smooth you have to print them in separate gcode files, i hide the Z seam by using Smart hiding on the lid and Hide seam on the container itself.

Category: Keychains