1 / 2
Bowens Mount 35MM Slide GOBO for Impact and Godox with Nikon Lens — zdjęcie 1
1 / 2

Bowens Mount 35MM Slide GOBO for Impact and Godox with Nikon Lens

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Modular slide film GOBO using Nikon lenses for Impact and Godox strobes using Bowens mount.

Ocena
0 / 5
Polubienia
8
Pobrania
62
Wydruki
0
Wyświetlenia
1253
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Photo & Video
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Two-piece 35mm slide GOBO for Nikon lens and Impact or Godox strobes.  This allows the use of any 35mm slide or patterned transparency mounted in a 35mm slide as a GOBO for creative lighting effects.

This was one of my first designs in tinkercad and is a little crude.  I might come back to update it at some point, but it is as it is for now.  Assembly requires printing the front piece and one of two rear pieces.  The deep rear piece has been tested on Impact (B&H store brand) 400WS Astral Extreme strobes, and the shallow rear piece has been tested on Godox clamshell mounts for speedlights/battery strobes.  The rear piece also contains a shelf where an optional ground glass can be added. This aids in reducing hotspots in the projection at a cost of cutting the light by 1-2 stops.  If you choose to add this, you'll need a cheap 52mm UV filter from amazon that can be removed from the ring and sanded.  Glue or epoxy this in place.

I added vent holes to the design in order to minimize heat buildup, however use of a modeling light with PLA/PLA plus can still cause warping/drooping.  I would highly recommend in using a higher temperature material such as Nylon or PC, and lining the inside with aluminum HVAC tape.

For the lens, any manual Nikon/Nikkor lens will work, I've had best results using a 24mm f/1.4 and a 50mm f/1.4.  

Tagi