Kossel Board Holder Micromake v1 board
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I felt the original was a bit too filmxy and I didn't like that the board sat without any standoffs, I added nut holes…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 108
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
I felt the original was a bit too filmxy and I didn't like that the board sat without any standoffs, I added nut holes on the bottom to help for threading and raised the board up about 2MM to allow for more airflow, to replace the removed under fin I added two side stabilizer rails that are designed to allow for the wiring to be freely connected though it has an enlarged opening on the power supply side to allow for easy wiring of the heater. To further strengthen it a cosmetic faceplate cover. Please note that you may need to drill the holes in the faceplate to allow for easier fitting of the m4 bolts but they can also be simply threaded in.
Parts required are
4 M4-10 bolts
2 M4 T-nuts.
4 M3-6 Bolts
4 M3 Nuts
Print Settings
Printer Brand:
Creality
Printer:
CR-10
Rafts:
No
Supports:
Yes
Resolution:
200
Infill:
20
Category: 3D Printer Parts