1 / 23
Dom Foot - workshop jig to hold Festool Domino parts — zdjęcie 1
1 / 23

Dom Foot - workshop jig to hold Festool Domino parts

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is the Dom Foot, a little helper for your workshop. If you have a Festool Domino joiner DF500 or even DF700…

Ocena
0 / 5
Polubienia
46
Pobrania
294
Wydruki
0
Wyświetlenia
1790
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is the Dom Foot, a little helper for your workshop.
If you have a Festool Domino joiner DF500 or maybe even DF700 this might come in handy.

Depending on the project you might need to oil or paint pieces before glueing them together.
That's at least why I need it now and then, so I made these parts.
You might have other plans what you need these for.

The Dom Foot design contains a whole set of parts.
You have the basic Dom Foot and additional inlays depending on the size of your domino.

They all go in and out of the same basic foot and come as tenon or mortise.
The tenon parts are for small to mid-sized parts.
Use your Domino as usual and to have it upright after coating use two or more tenon parts.

They can be used single or to secure parts from tipping over, just combine it with the basic foot. To secure it even better - for example angled cuts - screw the Dom Foot down to a board.

Even better in such cases with high duty or larger parts: the mortise variant.
Because the tenon is stressed shearing, it can't take high forces.

Just insert a Domnino in the mortise part and you will have a heavy duty jig.

The tenon and mortise parts come in all common Domnino sizes and they have length combinations as following:

4 x 10 mm
5 x 15 mm
6 x 20 mm
8 x 25 mm
10 x 25 mm
12 x 25 mm
14 x 25 mm

So you'll get the whole set here and any updates that will come.

Main purpose is to help everyone using a DF500 though it's the same principle and should work with DF 700 Dominos just as well.

Though I wouldn't recommend using it for huge parts with 14 x 140 Dominos.

For storage you can stack the parts together and I think the parts are determined to be printed in different colours, so you can recognize their size easy.

If your are using T-tracks in your workshop, check out this version to get more out of this jig.

 

 

Print Settings

Printer Brand:

Anycubic

Printer: 

i3 Mega

Rafts:

No

Supports: 

No

Resolution:

0.2 mm

Infill: 

50 %

Filament: das Filament PLA Orange


 

Notes:

Layers: 0.2 - 0.3 mm (might use adaptive layers)
Infil: ~50%

walls: 3

nozzle: 0.4 mm

Everything the settings I used so far.

Tagi