Magnetic DragonLock Clips - 3mm Magnets
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is my own iteration of the DragonLock Cavern/Dungeon edge covers. These are magnetic versions and will easily…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 330
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution
This is my own iteration of the DragonLock Cavern/Dungeon edge covers. These are magnetic versions and will easily clip onto the DragonLock magnetic clips. This allows for easy/on-the-fly changes to the tiles on the table, and makes it easy to show the players the map as they go through it.
DragonLock Cavern/Dungeon Edges; https://www.drivethrurpg.com/product/221625/DRAGONLOCK-Ultimate-Dragonlock-Edges
DragonLock Magnetic Clips; https://www.fatdragongames.com/fdgfiles/dragonlock-ultimate-interlocking-terrain-system-allows-create-fully-modular-multi-level-28mm-scale-dungeon-terrain-rpg-wargame-home-3d-printer/
DragonLock Magnet Clip re-mix (3mmx2mm Cylinder magnet); https://www.thingiverse.com/thing:5823020
Dungeon Edge v2 - 3mm Ball Magnet;
Dungeon Edge v2 (ball).stl
Dungeon Edge v2 (holder).stl
Dungeon Edge v2 - 3mmx2mm Cylinder Magnet;
Magnetic Dungeon Edge_3mmx2mm.stl
Dungeon Edge v2 - 3mmx1mm Cylinder Magnet;
Magnetic Dungeon Edge_3mmx1mm.stl
Cavern Edge v2 - 3mmx2mm Cylinder Magnet;
Magnetic Cavern Edge_3mmx2mm.stl
Cavern Edge v2 - 3mmx1mm Cylinder Magnet;
Magnetic Dungeon Edge_3mmx1mm.stl
Print Settings
Printer Brand:
Creality
Printer:
Ender 2
Rafts:
No
Supports:
No
Resolution:
.15
Infill:
20%
Filament: eSun/Inland PLA+ Grey Post-Printing =============
Cylinder Magnets
Post-Cleanup, use an 7/64 drill bit to cleanup the magnet holes. This will allow the magnets to fit snug. If needed, an drop of glue in the magnet hole will insure they stay in.
Insure the magnet's poles line up with your other magnetic clips.TIP; put the cylinder magnets onto an magnetic clip in another tile, and then push the edge onto those magnets to set them in. This will insure they are aligned up polarity wise to the other clips.
3mm Ball Magnets
Insure the holder is clean inside, so the ball magnets can slide around. They should be able to stick outside the hole a bit to insure they can grab onto the other magnetic clip.
The holder should fit snug into the edge cover. If needed, very little sanding can be done on the edges to allow it to slide into the edge and stay in there. If needed, a little glue can be put on the outer edge of the magnet holder before it's slid into the edge. This will help make sure the holder stays inside the edge.
Category: Games