boot/trunk hanger for GD chassis Subaru Impreza
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A bag hanger for Subaru Impreza sedans on the GD chassis (bugeye, blobeye, hawkeye).
- Ocena
- 0 / 5
- Polubienia
- 13
- Pobrania
- 45
- Wydruki
- 0
- Wyświetlenia
- 446
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I'd seen hangers able to be bought off the shelf for later-model WRXs and thought they looked really useful for stopping shopping bags sliding around in the boot. I wanted one myself, but couldn't find one for my hawkeye.
This one attaches to existing stamped holes in the top of the boot of the car; put it together with some M4 nuts and bolts (there are spaces in the model to hold the nuts captive), leaving the connection between the bracket and the bracket grips a little loose. Once it's all together, you'll be able to fit the grips into the two round holes, slide the whole assembly towards the back of the car to seat into the notches, and then tighten up.
I initially printed this in PLA, and it worked really well until I had a reasonably heavy bag hanging loose on it and took a few corners enthusiastically; the bracket broke at the layer lines. I've since re-printed in PETG and had no issues. It could well just be an issue with the layer adhesion in my original print rather than any actual gain in the change of materials though.
You'll want to print two of the bracket grips of course, and piece together with 2x 20mm M4 bolts and 1x 30mm M4 (plus 3x M4 nuts).