1 / 2
Mortise Door bolt (for 1940's and 1950's era hardware) — zdjęcie 1
1 / 2

Mortise Door bolt (for 1940's and 1950's era hardware)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

These are quick and dirty models of a mortise door knob bolt that I have in my house, with linear spring and without.

Ocena
0 / 5
Polubienia
1
Pobrania
10
Wydruki
0
Wyświetlenia
150
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

These are two quick and dirty models I made in about an hour for the broken bolt in my mortise door hardware.

The tongue of the bolt is the actual piece that had broken off in my case (photo included with a VERY early prototype), but the rest of the door handle was functional. I decided to include a linear spring in one of the models just because it might be cool, but I've found that PETG wasn't the best material for the shape and workload of the spring. I then decided to make a better recreation of the bolt and require a separate coiled spring. 

I also printed a bolt in ABS, and it works much better with the linear spring, not deforming nearly as much as PETG and being a little stiffer, which helps with the snap back.

Next, I'm going to try PLA to see how it works for the linear spring I included. 

One caution: I noticed that these bolts cause the doors to quietly close, which is a GOOD thing if you want a quieter house, but can be a bad thing if you like the healthy sound of a door closing behind you.

Needs to be printed with supports there is a 1mm void between the majority of the bolt body and the surface.

Tagi