1 / 12

Retro Toy Race Car "Baghera"

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A Race Car you can actually play with! Based on the Baghera toy car.

Aktualizacja u źródła: 19 lis 2023

Informacje o modelu

Always loved the Baghera toy cars, so I made a printable version of one of them which is not sold anymore, with a little bit of my own twist.

01 Body

It is optimized to print upwards (front on the bed), which makes the nicest finish. No support or brim needed. 15% infill

02 Grille

Print the grille with the position as it is mounted (with ornament on top). No support needed, but a brim is recommended. 15% infill

03 Head

Print the head with tree support with the pin facing downwards. 15% infill

04 Axle (4x)

There is a flat part on the axle where it is placed on the bed. No support needed. Print solid.

(it can be a bit difficult to press in the body, but it needs to be tight)

05 Rim (4x)

Speaks for itself… 15% infill

05 Tire (4x)

I created the white wall by adding a ‘filament change’ script at layer height 83. Base is TPU and the white wall is white PLA. 15% infill

06 Wheel cap (4x)

Print with the round part down. Not optimal for the snap, but it does not have to hold much.. Print solid. I needed no brim.

Note: it can be assembled in only one way. With the slot vertical.

07 Exhaust (2x)

The exhaust needs support and a brim. I suggest to mirror the exhaust, so the “ugly” part is always facing down

Enjoy! And do you have any suggestions/problems, let me know!