GL iNet Slate AX Wall Mount w Fan
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Wall mount bracket for GL iNet Slate AX travel router. Supports 2 Raspberry Pi fans 30x30
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 94
- Wydruki
- 0
- Wyświetlenia
- 1654
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
I needed a way to mount my Slate AX travel router, thus this design was born. It requires removal of the soft sticky feet pads on the bottom of the router. The two front-facing pegs go into the recessed screw holes (behind the soft feet that you removed), and expand for a friction fit once you insert the 3mm screws into the wall mount bracket.
This bracket also supports the use of two Raspberry Pi 30x30 fans, which I recommend wiring in parallel to a USB pigtail for 5v power. Use the included spacer bracket to allow for some air flow to occur between the wall and the bracket.
Preparation:
- Four 3mm countersunk screws required, at least 8mm long to secure the bracket to the router
- Two 3mm screws are required to mount the bracket to the wall
- Suggest printing at 0.2mm layer height with 0.4mm nozzle
- 0.6 nozzle is NOT recommended due to the small size of the slotted front pegs
- PETG is preferred because it allows the slotted front pegs to flex without breaking as easily compared with a stiffer material
I respond to comments so feel free to provide feedback or ask questions!