1 / 4
Pocket Containers for MK2 (Maker Parts 2 - All Metal) — zdjęcie 1
1 / 4

Pocket Containers for MK2 (Maker Parts 2 - All Metal)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

The Maker Parts 2 (All Metal) Printer has a hole on each side of the print bed that were ideal for a couple of little…

Ocena
0 / 5
Polubienia
0
Pobrania
9
Wydruki
0
Wyświetlenia
98
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution

The Maker Parts 2 (All Metal) Printer has a hole on each side of the print bed that were ideal for a couple of little containers to hold printing accessories and stuff (AKA: the hex wrench that I keep losing).

The design is pretty simple but fits well.

La impresora MakerParts 2 (All Metal) tiene dos secciones caladas (una a cada lado de la cama) que son ideales para un par de contenedores para guardar accesorios y cosas (ejemplo: la llave hexagonal que suelo perder)

El diseño es muy sencillo pero encaja bien.

Print Settings

Printer:

Maker Parts 2 All Metal

Rafts:

Yes

Supports:

Yes

Resolution:

.2 mm

Infill:

15%

Filament:

Maker Parts 2 - PLA PLA

Black


Notes:

Nothing special needed for such a simple design.
I printed them on the side (with the short lateral down) in order to save on supports.

about 30g of filament

Es algo tan sencillo que puede ser impreso sin complicaciones.

Yo los imprimí de costado (con el cateto chico del triangulo como base) para ahorrar soportes.

unos 30g de filamento

How I Designed This

I simply measured the opening and clearances and designed in sketchup.

The left side came out perfect in the first try.

The right side ... not so much, the picture is for the v3 (and took some convincing in order to fit). The design included is for v4, that should fit perfectly (I haven't tested it, as I'm too cheap to waste filament :-) )

Simplemente medi las aberturas y los espacios que la rodean y lo diseñe en sketchup

El de la izquierda salió perfecto a la primera.

El de la derecha ... requirió bastante mas trabajo. La foto corresponde a la version 3 (que necesito un poco de convencimiento para entrar en su lugar), pero el diseño es de la versión 4 que esta corregida y debería calzar perfectamente (pero no lo se, porque no queria gastar filamento)

Category: 3D Printer Accessories

Tagi