1 / 3
Proxxon PD250 lathe belt tensioner stop — zdjęcie 1
1 / 3

Proxxon PD250 lathe belt tensioner stop

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Prevent the belt tensioner from falling out of its slot (every time you change belt positions!)

Ocena
5 / 5
Polubienia
6
Pobrania
46
Wydruki
1
Wyświetlenia
730
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I got very fed up of the belt tensioner falling out of the bottom of its slot on my Proxxon PD250/e lathe, and eventually got round to drawing this thing to fit into the bottom of the slot, and block the tensioner from falling too far. It's a big quality of life improvement for a ≈6 minute print.

You can tap the hole M3 if you want to add a handle to it - I didn't find this necessary though.

I printed in PETG, although most filaments should work.

Tagi