Anycubic Kobra Low Profile 2x LED Strip mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Low profile strip that fits into the Anycubic Kobra holes of the top bar. Wide enough for 2 strips, possibly 3
- Ocena
- 5 / 5
- Polubienia
- 14
- Pobrania
- 142
- Wydruki
- 1
- Wyświetlenia
- 1187
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Anycubic Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
I wanted super low profile attachment to put lighting on my Kobra Go. I had been using a clamped on gooseneck lamp but it was very obnoxious and obtrusive.
I printed this in PLA+ and have black light strips currently attached to it and it is holding up fine. They do not get hot enough at all for it to warp, and I have it held up on velcro strips on both sides in case it decides to work it's way free.
The cords run through the upright arm, I wedged them in the groove of the vslot where the roller is.
Depending on your printer settings, you may need to scale 101%