1 / 4
Replacing the plastic part of the handlebar of the hiper model b2 elrctric scooter — zdjęcie 1
1 / 4

Replacing the plastic part of the handlebar of the hiper model b2 elrctric scooter

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Replacement to get rid of steering backlash

Ocena
0 / 5
Polubienia
0
Pobrania
15
Wydruki
0
Wyświetlenia
206
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

The original plastic part has a large backlash and is attached by self-tapping screw, which also over time loosens. There are two holes on the steering wheel to attach the plastic part, the regular one is attached only at the bottom.  The lower one is very close to the edge and the screw channel makes the part brittle in this place. That is why I gave up the lower screw and left only the upper one. The part was printed completely out of the walls for strength. The material was ABS, and after printing I treated it with dichloromethane. The size of the model is a little larger to compensate for the shrinkage of the ABS plastic. If it doesn't fit, it needs a little sanding. For assembly you will need a m4 screw ~15 mm and a nut. The screw should reach the nut, but it should not be too long so that it does not catch on the opposite wall.