DIY 5K Monitor v2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
DIY 5K Monitor project with 2x Display Port 1.4, 2x HDMI, and USB-C with PD. Also has IR remote to switch inputs.
- Ocena
- 0 / 5
- Polubienia
- 23
- Pobrania
- 240
- Wydruki
- 0
- Wyświetlenia
- 2783
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I really wanted a 5K monitor but didn't want to pay for a really expensive Apple monitor or the LG Ultrafine display. Besides the cost, they also only have Thunderbolt ports and I wanted the option to use HDMI and regular DisplayPort cables too. My solution was to order just the panel that comes in the 5K iMac and also is the same panel that comes in the LG Ultrafine Monitor. From the same store I was able to buy a driver board that would power the panel and give me the ports I was looking for. The difference between package A and B is that B also comes with the power supply so I recommend you get that one if you also need the power supply.
Once I had the panel and board I was able to mount them temporarily on a piece of plywood to test them out but I wanted a better solution for an enclosure so I made one for the driver board with my 3D printer and then ordered a flat steel back panel from oshcut. This normally would have cost me $86 but I got a referral link from JerryRigsEverything's Hummer EV video that gives you $45 off your first order (See his video description for the code).
The steel back panel has holes that let you mount it directly to the holes on the back of the display panel. This will use 16 M3x5mm screws. The current design of the controller board has it mounted to the bottom backside of the display and you can slide it up and down to hide it or show it. This is something that will probably evolve as I use it and think about it some more. Part of me wants to solder extensions to the controller board so I can make my own board without needing to have the big ribbon cable have to move up and down with the buttons.
Parts:
- Buy - 5K Display Panel LM270QQ2 - $270
- Buy - 5K Driver Board for LM270QQ2 - $250
- Order 2x Steel Back Panels from OSHCut (Outer and Inner panels. Don't forget to use the coupon code mentioned above for $45 off your first order.)
- 3D Print - Driver Board Case and the Controls Case parts.
- (23x) M3x5mm Button Head Screws:
- 16x of these screws to mount display panel to steel back panel.
- 4x of these screws to mount the driver board to the 3D printed enclosure (R1811 Driver Board Case Back file).
- 3x of these screws to hold the lid on the driver board case.
- (4x) M3x5mm Flat Head Screws and nuts to mount driver board enclosure to back panel
- (10x) screws for controller board enclosure.
- (1x) M3x4mm Button Head Screw to mount top of front slider to back panel
- (2x) M3x8mm Button Head Screws to mounts sides of front slider to back panel
- (5x) M2x6mm Button Head Screws to hold the controls case together.
- (2x) M2x10mm Button Head Screws to also hold the controls case together.
Here are the videos I have so far featuring this build: