Beefy Little Lack Paver Brace

Brace Details:

• The braces are designed to support the corners of the concrete paver embedded into a Lack table.
• The screw holes on the braces are positioned strategically to ensure they thread into the structural areas of the table legs.
• The inside edge of the braces has a chamfered to facilitate a flush and square fit.
• #8 ¾" counter sunk screws are used to attach the braces to the table.
• CAD file is included to modify to your needs.

Print Settings:

• 0.8mm nozzle
• 4 perimeters
• 15% infill

The wall thickness should be around 3-4mm, but you may need to adjust this based on your own printing settings.

Paver Instructions:

Prepare Cut:

1. Mark the area on the Lack table top where you will cut.
2. Measure the width of your table (A) and the width of the paver (B).
3. Subtract A from B (B - A) to get the difference.
4. Divide the difference by two and measure inward from each corner of the table to place marks.
5. Connect the marks using a straight edge.
6. Cut out the marked section from the Lack table top.

Prepare the Inside of the Table:

1. Drill out the four corners of the marked box on the table.
2. Use a saw to cut along the edges of the marked box.
3. Pry out the inside "lid" of the table. It may be held in place by weak glue.
4. Use a utility knife to cut the core material along the edges of the top cut.
5. Pinch out the core material from the bottom, as it should separate easily.
6. Place dampening pads in the corners to provide support for the paver.

Place the Paver:

1. Put the table back in its original position.
2. Place the concrete paver into the cavity created inside the Lack table.

Enjoy!