Surface mount for Siemens FS100 surge protector
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is used to surface mount a Siemens FS100 whole home surge protector.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 172
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial
Needed to surface mount my new Siemens FS100 whole home surge protector. The kit from the manufacturer was $100+ for a piece of metal and some hardware. Took measurements and created this print. Since I could not print in one piece, it is designed with 3mm holes in it. I ordered 2.5mm x 100mm steel rods that fit into the holes. When it is all assembled, this provides structural rigidity. I also used an M4 nut/washer kit along with 75mm sleeve coupling nuts to mount the surge protector to this. Picture shows all of the parts needed.