Prusa Mini+ light - snap together wider LED inlets

Overview:
Remix of 'Snap together Mini+ light' by @Aargon_207387 with wider inlets for LED strips, for example 14mm wide.

Please give a like and post makes and provide comments for further improvements.

Known limitations:
Due to the fact that I forgot in one place supports (derp, and was too lazy to print it again) I can not guarantee all snaps in to the place smoothly - you will have to use some tools to adjust the connections, but basic filer should be sufficient.

Still I was sure I will used glue which provides some filling volume such as Poxipol.
After gluing all parts you are able to remove short bridges in the connection areas, getting one large U shaped light mount, as seen on the last images. The structure after gluing with Poxipol is much more rigid than I expected, even after removing the short bridges.

Dimensions:
- 30cm width from the front
- 23cm depth from the front

Changes:
- split to multiple smaller parts
- added more holes to allow install LED strips on the corner joints
- allows to install led strip with 14mm wide
- improved strength aroud screw holes a bit

Print:
- current model is split into parts to be printed flat so it is better to print it with supports, but notice on the photos the quality issues on the edges that I had.
I used Prusament PETG 0.20mm on 150% speed
- (not tested) optionally you can rotate all parts to the side so that they are printed more upward and then all parts fit in the Prusa Mini+ print bed, also in that position supports may not be needed.