Laserparametertest for Snapmaker an other lasers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a gcode-file which is burning several filled rectangles on your material. I choosed to go from 10 to 100% in…
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 64
- Wydruki
- 0
- Wyświetlenia
- 430
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Share Alike
This is a gcode-file which is burning several filled rectangles on your material.
I choosed to go from 10 to 100% in ten steps and for the speed I started from 300mm/min up to 3300mm/min in three hundred steps.
Be careful, some materials will burn away with the 10W-Lasermodule!
The projectfile can be edited in Luban and the gcode should work right without
adjustments on a Snapmaker A350.
I also added the 110 .json-files if you want to make your own set of settings.
You can import them one by one but that is a bit of pain in the arse. On MacOS, you can copy them to the right subfolder in /Users/$Your Username/Library/Application Service/snapmaker-luban/... On windows it is C:\Users$user\AppData\Roaming\snapmaker-luban\Config\laser
The pictures show the file burnt on a piece of slate and a plate printed with yellow PETG.
Category: DIY