Traeger Pellet Chute
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
UPDATE (01/11/2022): I have added a curve to the bottom of the chute to better concentrate the pour from the hopper.…
- Ocena
- 5 / 5
- Polubienia
- 21
- Pobrania
- 180
- Wydruki
- 1
- Wyświetlenia
- 1030
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
UPDATE (01/11/2022): I have added a curve to the bottom of the chute to better concentrate the pour from the hopper. In testing it has proven to be a noticeable improvement over the original.
UPDATE (11/08/2021): I have added a new "shorter" version that might better fit some 3D printers. This is still a fairly large object and may not fit on many consumer sized 3D printers.
I noticed that when I dumped my pellets out of the Traeger grill that they kind of went everywhere, so I developed this chute to help guide them into the bucket. I added some stick on magnet "tape" to the back and it holds it just well enough to keep it in place while swapping out pellets.
I do not recommend leaving this on the grill during use and tend to store it with my pellets.
Here's a quick video of it in use: https://youtu.be/sDfkRgXptGM
Print Settings
Printer Brand:
LulzBot
Printer:
TAZ 6
Rafts:
No
Supports:
Yes
Notes:
This could be printed flat without need for supports if your printer is large enough. it was just slightly too large for my Taz6 so I had to orient it in such a way as a single support was needed for the upper lip of the chute (see last image).
Category: Outdoor & Garden