3Dconnexion box

Please split the file into its two components an align them properly using the tools in PrusaSlicer.  Supports are not required, I recommend to use separate layer heights for each part, as the lid may be difficult to open and close when the layers of lid and body match. In my tests I found 0.2 millimeter for the base and 0.15 millimeter to be the best as this results in a minimal alignment of the layers of the two parts.

I mainly made it because all other designs I found were to complicated, to big or would bend the cable to much.

Please make sure you have the right 3Dmouse as to my knowledge it was redesigned to be easier to grip or look better, this case is for the old version of the mouse. 

Also if you have any ideas for improvement let me know. I am providing f3d(with a very messy construction timeline), step, and 3mf file formats so everyone who is not satisfied with my design, because of minor things, can change the things they don't like.

Happy Printing!